4) BIOFX485 READER (RS 485)
Notice technique / Technical manual - ENCOD-USB – V1.0
4) BIOFX485 reader (RS 485)
Caution:
To connect BIOFX485 readers, your C4PLUSFX central unit must be a revision B model with
version 4.0 or later. The SENATORFX version used must be 5.0.7 or later.
Note:
You can connect up to
4 BIOFX485 readers on each
C4PLUSFX
(?)
Data sheet:
SYT recommended
Ø 0.6 mm
2 pairs recommended
12 V DC power supply
Ensure you use the same pair for A and B
Disconnect the power supply from the bus
RS485
Characteristic:
Screen:
Recommended
To achieve 1200m, you need to install a 220
resistor at each end of the network between
points A and B (see above).
Note:
The total length must not exceed the
recommended distance.
Sensitive connection
p.27/38