TYPICAL ARRANGEMENT FOR CONNECTION
Notice technique / Technical manual - ENCOD-USB – V1.0
Typical arrangement for connection
1) Aerial activated on the C4PLUS FX control unit
+
-
12V DC power
supply
(?)
Data sheet:
3 wires
100 m
0.6 mm
Ø
Relay 2
Relay 1
Characteristic:
Sensitive connection
Screen:
Optional
Simply connect the three wires on the reader to the control unit
terminal block as shown.
Note:
Do not position the control unit-receiver wires close to other
live or high voltage cables, and specifically not close to 220 V
cables or higher.
Relay 1
Relay 3
Relay 4
p.24/38
Radio receiver (JCM,
TECHNO EM, etc.)