cefar primo Mode D'emploi page 18

1. Attach the electrodes to the cables.
If carbon rubber electrodes are being
used, spread on an even layer of gel.
Wash and dry the skin well before
attaching the electrodes.
2. Turn the stimulator on with
If you wish to use the same settings
as last time you stimulated, you can
start stimulation directly by setting
the desired amplitude with
each channel.
3. To choose program press
each channel until the wanted
program is shown. NOTE! This can
only be done when both channels are
set to 0.0 mA.
4. Start stimulation by selecting the
desired amplitude with
channel.
Program: Stimulation form:
P1 Conventional TENS
P2 Burst TENS
P3 Modulated pulse duration TENS
P4 Mixed frequency TENS
P5 Mixed frequency TENS
P6 Nausea treatment
P7 Facial treatment
P8 Conventional TENS
P9 Burst TENS
NOTE!
20 seconds after the amplitude has been
set the key lock is automatically
activated. Deactivate the key lock by
pressing one of the
.
Note with mixed frequency TENS
(P4 and P5):
One amplitude for each frequency is
for
being set, to make the stimulation
comfortable. Instructions: First set one
for
amplitude for conventional stimulation
(15 Hz or 80 Hz) and then, when the
stimulator after 3 seconds switches over
to burst stimulation (2 Hz), set the
amplitude for this frequency. mA is lit
with conventional stimulation and
blinking with burst stimulation.
for each
Frequency:
80 Hz
2 Hz
80 Hz
15 Hz/2 Hz
80 Hz/2 Hz
10 Hz
80 Hz
80 Hz
2 Hz
buttons.
Pulse duration: Timer:
180 µs ---
180 µs ---
70–180 µs ---
180 µs ---
180 µs ---
180 µs ---
60 µs ---
180 µs 30 minutes
180 µs 30 minutes
19