CAPITAL SPORTS ROWLYMPIC Mode D'emploi page 26

EN
26
2 Wait until the water reservoir is fi lled. Now set up the rowing machine
again horizontally and open the fi ller plug on top of the tank.
3 Use the supplied hand pump to empty the water reservoir. Insert the
straight piece of the water pump into the water tank and the fl exible end
into a bucket to catch the water. By pushing the pump bag, you will pump
the water through the pump.
4 As soon as you can no longer pump water from the reservoir, set the
resistance regulator to maximum and wait until the remaining water has
fl owed into the lower half of the tank. Now place the rowing machine
vertically (1). The level in the lower half of the tank should be slightly
below the drain plug at this time so that no water leaks when it is opened
(2). Now use the pump as before to empty the lower part of the water tank.
If the water level is still above the drain opening, carefully tip over the
rowing machine so that some of the water fl ows back into the reservoir
until you can open the tank stopper. Now use the pump as before to empty
the lower part of the water tank (3 + 4). Repeat these steps until you have
removed all water from the tank.