Harrie Leenders Pharos Interior Instructions D'utilisation page 24

Finishing cover
Decorative pipe
Column
Mounting ring
9. Installing the decorative pipe and column
• Slide the decorative pipe (the slots at the upper end) and the column on
the stove pipe and move them upwards as far as possible) (the decorative
pipe slides over the cord and into the finishing cover).
• Also slip the mounting ring on the stove pipe moving it as tightly as
possible against the column and fasten it with the 3 M8 x 20 bolts (socket
or open-end spanner j.w. 13).
• Note: Place the mounting ring so that the long hexagon-head bolts
(M8 x120) are at the lower part and the three short screws (M8 x20) at the
upper part of the ring.
• Tighten the bolts firmly!
11. Hanging the stove
• Ensure that the welded seam in the stove pipe is on the
right-hand side and the fire opening on the front side.
• Jack the frame up until it fits over the stove pipe.
• Fasten the frame to the stove pipe with 3 M8x20 bolts.
(socket or open-end spanner j.w. 13).
22 GB
10. Preparing the stove
• Bring the pre-assembled frame to the place of installation using a
handtruck.
• Remove the stove-pipe support from the Pharos lifing jack.
• Place the sliding pieces under the lifting jack.
• Place the pre-assembled frame on the Pharos lifting jack (Ensure that the
lifting jack is in its lowermost position).
• Push the lifting jack holding the frame under the stove pipe; keeping
the fire opening at the front.
Welded
seam at
right-hand
side
Bolt
M8x20
12. Mounting the flap
• Hook the flap-control handle into the eye.
• Fasten the flap-control handle to the flap with the M6 x 20 bolt
with an M6 bodywork ring on both sides.
• Fit a self-locking M6 nut on the bolt and tighten it (socket or
open-end spanner j.w. 10).
• Check the flap for proper operation.
Bolt
+rings
+nuts
Flap-control
handle
Eye
together