CALIMA 46060 Manuel De L'opérateur page 5

5. OPERATING INSTRUCTIONS
5.1 OVERVIEW
4 Hook for pulling out tent rings
1 Hammer head
5 Pull-out
2 Hammer handle
6 Cleaning brushes for tent pegs
3 Handle
7 Pull-out lock
Figure 1: Overview
5.2 HAMMERING TENT PEGS
Before hammering tent pegs with the camping hammer, push
the pull-out (Position 5 in the overview) completely into the
hammer handle (Position 2 in the overview) until the lock clicks
into position (Position 7 in the overview).
5.3 PULLING OUT TENT PEGS
Pull the pull-out (Position 5 in the overview) completely out of
the hammer handle (Position 2 in the overview). Loop the hook
(Position 4 in the overview) into the tent peg. Hold the hammer
handle just under the camping hammer (Position 1 in the
overview) and pull the tent peg out of the ground without jolting.
5.4 CLEANING TENT PEGS
Pull the pull-out (Position 5 in the overview) completely out of
the hammer handle (Position 2 in the overview). Place the tent
peg into the cleaning brush (Position 6 in the overview). Move the
tent peg backwards and forwards in the cleaning brush. Knock the
dirt from the brush after cleaning. Push the pull-out (Position 5 in
the overview) completely into the hammer handle (Position 2 in
the overview) until the lock clicks into position (Position 7 in the
overview).
Picture 2: Cleaning brush
6.MAINTENANCE AND CARE
The camping hammer is maintenance-free if used properly.
After use, remove any dirt or sand from the pull-out and the clean-
ing brush before pushing it back into the handle.
7. INFORMATION ON ENVIRONMENTAL PROTECTION
Dispose of the suction pad in the recycling bin or the public/
communal collection points. The materials are recyclable. You
make an important contribution to protecting our environment
by recycling, material utilisation or other forms of reusing waste
equipment.
8. CONTACT INFORMATION
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com
5