Husqvarna K1 PACE Manuel D'utilisation page 28

Maintenance
Make sure that the power trigger and the power trigger lockout function correctly
from a safety point of view.
Do a check of the cutting blade. Look for cracks and make sure that the cutting
blade is not unusually worn. Replace if necessary.
Clean the fan housing on the product.
Make sure that the screws and nuts are tight.
Make sure that the control panel works correctly and that it is not damaged.
Do a check of the connections between the battery and the product. Do a check
of the connection between the battery and the battery charger.
Blow through the product and battery soft with compressed air.
To clean externally
WARNING:
washer to clean the product.
• Flush the product externally with clean water after
each day of operation. If it is necessary, use a brush.
To do a check of the power trigger lockout
1. Make sure that the power trigger and power trigger
lockout move freely and that the return spring
operates correctly.
28
Do not use a high-pressure
2. Push down the power trigger lockout and make sure
that it goes back to its initial position when you
release it.
3. Make sure that the power trigger is locked at the idle
position when the power trigger lockout is released.
Before
Weekly Monthly
use
X
X
X
X
X
1598 - 002 - 14.02.2022
X
X