Husqvarna K1 PACE Manuel D'utilisation page 15

Applicable cutting blades
CAUTION:
recommended cutting blades for K1
PACE and the material to be cut. The
recommended cutting blades decrease the
risk of serious injury and increase the
cutting and X-halt performance. If general
high speed cutting blades are used,
the performance and cutting quality will
decrease.
WARNING:
and abrasive blades for concrete and metal.
Do not use blades with serrations such
as circular wood cutting blades or blades
with carbide tips. The risk of kickback is
increased and carbide tips can come off and
be thrown at high speed. This can result in
injury or death.
WARNING:
for any other materials than what it was
intended to cut.
WARNING:
that comply with applicable national or
regional standards, for example EN12413,
ANSI B7.1. or EN13236.
WARNING:
with a rated speed value lower than that of
the product. The rated speed value of the
cutting blade is marked on the cutting blade
and that of the product is marked on the
type plate.
Note:
Many cutting blades that can be attached to this
product are made for stationary saws. The rated speed
value of those cutting blades is too low for this product.
1598 - 002 - 14.02.2022
Use Husqvarna
Only use diamond blades
Never use a cutting blade
Use only cutting blades
Do not use a cutting blade
100 m/s
XXXX rpm
WARNING:
blades with thickness exceeding maximum
recommended thickness. Refer to
data on page 33 .
• Cutting blades applicable to this product are
available in two basic models; bonded abrasive
blades and diamond blades.
• Make sure that the cutting blade has the correct
center hole dimension for the installed arbor
bushing.
Abrasive blades
WARNING:
with water. Water or moisture decreases the
strength of the abrasive blade and increases
the risk that the blade breaks.
CAUTION:
is not permitted with the Vac attachment.
Use of abrasive blade causes too much
wear on the Vac attachment.
WARNING:
on correct material.
• Do not use wheels from larger power tools. Wheels
of a larger power tool are not correct for the higher
speed of a smaller tool and may break.
• The cutting material on abrasive blades is bonded
with natural material that have a gravel bonded
agent. Blades that are made up of a fabric or fibre
are stronger. This type of blade does not break if
the blade gets cracks or becomes damaged during
operation.
• The performance of a cutting blade is given by
the dimension of abrasive grain, and the type and
hardness of the bonding agent.
Do not use cutting
Technical
Do not use abrasive blades
Cutting with abrasive blade
Use correct abrasive blade
15