Festool VB-CMS/CS50 Notice D'emploi page 5

1 Technical data
VB-CMS/CS 50
Bench dimensions, outer
(width x length)
Bench height
with foldaway legs
without foldaway legs
Weight
2 Symbols
Manual, read the instructions
The specified illustrations appear at the beginning
of the Operating Instructions.
3 Intended use
When the widener VB-CMS/CS 50 is fitted (on the
right or left side of the bench), the saw table of the
CS 50 EB or the basic unit CMS-GE is widened by
481 mm.
The user bears the responsibility for damage and
accidents caused by improper use.
4 Safety instructions
WARNING!
Read all safety warnings, in-
structions, illustrations and specifications provid-
ed with this tool. Failure to follow all instructions
listed below may result in electric shock, fire and/
or serious injury.
Save all warnings and instructions for future ref-
erence.
– Position the bench on a stable, level, horizontal
surface. If the bench slides or wobbles, it may not
be possible to control the power tool safely and
reliably.
– Do not overload the bench and never use it as a
ladder or trestle. Overloading or standing on the
bench will make it top-heavy and it will most like-
ly tip over.
5 Assembly
Ensure that the floor around the machine is lev-
el, in good condition and free of loose objects
(e.g. chips and offcuts).
773 m x 481 mm
900 mm
180 mm
11,3 kg
To fold out the legs [1-2] open the two rotary
knobs [1-1] to the stop. Tighten the rotary knobs
again once the legs are unfolded.
If necessary, loosen the screws [3-2].
Place the widener VB-CMS/CS 50 from above on
the groove of the CMS-GE/ CS 50 EB (Fig. [2]).
Ensure that the profile groove on the CMS-GE/
CS 50 EB and VB-CMS/CS 50 [3-4] are in align-
ment.
Adjust the height of the VB-CMS/CS 50 on both
sides using the screws [3-1] to the CMS-GE/
CS 50 EB.
Lock the VB-CMS/CS50 on both sides with the
screw [3-2] on the CMS-GE/CS 50 EB.
To ensure that the machine is stable and level,
the length of both legs can be altered by turning
the end caps [3-3].
Before using the equipment, ensure that the
profile plate is firmly secured in the bench
opening with the screw [3-5].
Disassembly
Disassembly is performed in reverse sequence to
assembly.
Alignment of the profile groove
Check after installation whether the pre-set profile
setting rail can be pushed without any problems
between saw table and table widener. If not:
Position the pre-set profile setting rail so that it
makes equal contact with the saw table and the
table widener.
Open the screws [3-2].
Secure the angle stop in the specified position.
Tighten the screws [3-2].
Information on REACh: www.festool.com/reach
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
Only use original Festool spare parts!
EKAT
4
Order No. at: www.festool.com/service
5
3
2
1
VB-CMS/CS 50
GB
5