Table Des Matières - AERMEC MGH R410A Manuel D'installation

OUT-LINE OF INSTALLATION
Installation
Requirements
The following should be
always observed for safety .3
Installation of indoor, outdoor
unit ............................................ 4
Flaring work and connection
of piping ................................... 6
Connection of piping(Indoor) .. 7
For right rear piping
For left rear piping
Connection of
piping(Outdoor) .................. 10
Connecting the cable
between indoor unit and
outdoor unit .......................... 11
Checking the drainage and
Forming the piping ................ 13
Air purging ............................ 14
Test running .......................... 16
Required Parts
Level gauge
Screw driver
Electric drill
Hole core drill(ø70mm)
Pipes: Gas side ....... 1/2", 3/8",
5/8", 3/4"
Liquid side .... 1/4", 3/8"
(Refer to page 4)
Insulation materials
Additional drain pipe
(Outer Diameter ....... 15.5mm)
Two type "B" screws
2
Required Tools
Installation plate
Four type "A" screws
Connecting cable
Flaring tool set
Specified torque wrenches
1.8kg . m, 4.2kg . m, 5.5kg . m,
6.6kg . m
(different depending on model No.)
(Refer to page 10)
Spanner..................Half union
A glass of water
Screw driver
Hexagonal wrench(4mm)
Gas-leak detector
Vacuum pump
Gauge manifold
Owner's manual
Thermometer
Holder Remote Control