Whirlpool WTW4616FW Guide D'utilisation Et D'entretien page 5

WASH
The washer will fill to the correct water level based
on the load size and the Water Level selection. Certain
cycles may agitate during the fill process to boost
cleaning. You will hear the agitator rotate followed
by a pause lasting several seconds. When the wash
cycle begins, you will hear the agitator increase speed.
The motor sounds may change at different stages in
the wash cycle while the machine performs different
wash actions.
RINSE
Certain cycles use a spray rinse, which adds water to
the tub while the basket spins. When Fabric Softener
"Yes" is selected, you will hear sounds similar to the
wash cycle as the washer rinses and moves the load.
You may hear themotor turning on briefly (short hum)
to move the basket while filling.
FINAL SPIN
The washer spins the load at increasing speeds for
proper water removal based on the selected cycle
and spin speed.
CYCLE COMPLETE
Once the cycle is complete, this light will come on.
For best results, remove the load promptly.
LID LOCKED
The Lock feature allows for higher spin
speeds. When lit, the lid is locked and
cannot be opened without pausing the
cycle. When the light is off, the lid can
be opened.
To open the lid after it has been
locked, press START/Stop. The lid
will unlock once the washer movement
has stopped. This may take several
minutes if the load was spinning at
high speed. Press START/Stop while
the lid is closed to resume the cycle.
5