Control Panel And Features - Whirlpool WTW4616FW Guide D'utilisation Et D'entretien

Control Panel and Features

1
WASH TEMPERATURE
1
Wash Temperature senses and maintains uniform water
temperatures by regulating incoming hot and cold water.
Select a wash temperature based on the type of fabric
and soils being washed. For best results, and following
the garment-label instructions, use the warmest wash
water safe for your fabric.
On some models and cycles, warm and hot water may
■
be cooler than your previous washer.
Even in a cold- and cool-water wash, some warm water
■
may be added to the washer to maintain a minimum
temperature.
All rinses are cold.
2 FABRIC SOFTENER
This option must be set to "YES" if using fabric softener
in the fabric softener dispenser. This ensures that fabric
softener is added at the correct time in the rinse for
even distribution.
3
WATER LEVEL
If you would like the machine to automatically sense the
appropriate water level for the load size and type, turn the
Water Level knob to the Auto Sensing setting.
If you would like to add the maximum amount of water to
your wash cycle, turn the Water Level knob to the Deep
Water Wash setting.
NOTE: Expect longer cycle times due to extended fill times
when using the Deep Water Wash option.
4
WASH CYCLE KNOB
Use the Wash Cycle knob to select cycles on your washer.
See "Cycle Guide" for detailed descriptions of cycles.
4
2
3
Not all features and options are available on all models.
Appearance may vary.
START/STOP BUTTON
5
Press to start the selected cycle; press again to pause the
cycle and unlock the lid.
NOTE: If the washer is spinning, it may take several minutes
to unlock the lid. Press and hold for 3 seconds to cancel a
cycle.
6 CYCLE STATUS LIGHTS
The Cycle Status Lights show the progress of a cycle. At
each stage of the process, you may notice sounds or
pauses that are different from your previous washer.
SENSING/FILL
When the Start/Stop button is pressed, and the Water
Level knob is set to Auto Sensing, the washer will fill
and begin sensing to determine load size and balance.
Once sensing is complete, the washer will fill to the
appropriate level for the detected load size and then
begin the wash phase of the cycle.
NOTE: Sensing and wash phases will be paused by
opening the unlocked lid. Close the lid to resume the
cycle. If the lid is left open for more than 10 minutes, the
washer will cancel the cycle and pump out the water.
The lid will lock after the wash phase to begin the initial
spinout and remain locked for the remainder of the cycle.
4
5
6