Bosch GTA 2500 W Professional Notice Originale page 21

OBJ_BUCH-854-002.book Page 21 Sunday, January 4, 2009 12:35 PM
Preparing the Saw Stand
Setting Up the Saw Stand
(see figure F)
Before fastening the attachment sets and the
power tool, the stand base must be pulled
apart.
– To relieve the limit bolts 20, lightly pull the
saw stand upward by the handle 6.
– Release lock 3.
This pulls back the limit bolts that lock the
wheels in place.
– Position one foot on the foot lever 14 and
push the handle 6 downward with both
hands until the limit bolts can engage again
on the other side of the locking plates 21.
– Tighten lock 3 as well as lock 9.
The height-adjustable legs 7 are used for level-
ling the saw stand.
– Loosen lock nut 22 and screw the legs in or
out until the saw stand is aligned level.
Preparing the Attachment Sets
(see figures G1–G4)
– To release the attachment set 1, press but-
ton 23 and open lever 24.
– Position the attachment set on the saw stand
2 and slide it to the red stop 25.
– Close lever 24 again. The attachment set is
now firmly positioned on the saw stand.
– Measure the distance x between the mount-
ing holes and your power tool.
– Release the second attachment set and posi-
tion it at the matching clearance x to the al-
ready fastened attachment set.
– Close lever 24 again.
Bosch Power Tools
Fastening the Power Tool to the Attachment
Sets (see figure H)
– Position the power tool in the transport posi-
tion. Notes on the transport position are giv-
en in the operating instructions of the re-
spective power tool.
– Position the movable nuts 26 in the attach-
ment sets so that they match the mounting
holes of the power tool.
– Screw the attachment sets and the power
tool together with the respective washers
and bolts.
Operation
Working Advice
Do not overload the saw stand. Always observe
the maximum carrying capacity of the saw stand
and the two table extensions.
Before working, always make sure that both
locks 9 and 3 are closed.
Always hold the workpiece firmly, especially the
longer and more heavy section. After cutting
through the workpiece, the centre of gravity
may become dislocated in such an unfavourable
manner that the saw stand tips over.
Preparing the Workpiece Support
Long workpieces must be underlaid or support-
ed at their free end.
Adjusting the Height of the Workpiece Support
(see figure I)
– Place your workpiece onto the saw table of
the power tool.
– Loosen locking knob 10 and adjust the height
of the workpiece support 12 so that the
workpiece rests level.
– Retighten the locking knobs again.
1 609 929 S19 | (4/1/09)
English | 21