Indications, Operating Controls, And Connections; Operating Control Led - Resol Datalogger DL2 Manuel Version Courte

5

Indications, operating controls, and connections

The following elements are featured on / in the housing of the DL2 Datalogger:
 Operating control LED / Reset button
 Memory capacity and VBus ® signal LEDs
 LAN connector
 SD memory card slot
Power supply connection (inside the housing)
VBus connection (inside the housing)
®


Positions of the operating controls and connections
20


5.1

Operating control LED


The operating control LED  indicates the operating status of the DL2 Datalogger
by issuing flashing signals.
LED flashing codes
Colour Permanent
Green • The SD card can be
removed.
• The firmware update is
completed.
Orange • Power supply is work-
ing and the device is
ready for operation.
Off • The device is booting.
• No power supply.
Flashing
• Do not switch off power supply!
A firmware update is being run.
• Do not remove the SD card!
Data are being copied onto the SD card.
• An error occurred during the copy
process.