Publicité
Les langues disponibles
Les langues disponibles
Mode Selection (Fig. E)
WARNING: Do not select the operating mode when the
tool is running. Tool must come to a complete stop before
activating the mode selector button or damage to the tool
may result.
Your tool is equipped with a mode selector dial
mode appropriate to desired operation.
symbol
Mode
Bit
Adjustment
hammering/
Chipping
To Select a Mode
•
Rotate the mode selector dial so that the arrow points to the
symbol corresponding for the desired mode.
nOTE: The arrow on the mode selector dial
at a mode symbol at all times. There are no operable positions
in between.
Indexing the Chisel Position (Fig. E)
The chisel can be indexed and locked into 24 different positions.
1. Rotate the mode selector switch
the
position.
2. Rotate the chisel in the desired position.
3. Set the mode selector switch
Chipping" position.
4. Twist the chisel until it locks in position.
Performing an Application (Fig. A, E)
WARNING: TO REDUCE THE RISK OF PERSONAL
INJURY, ALWAYS ensure workpiece is anchored or
clamped firmly.
nOTE: Operating temperature of this tool is 7 to +40˚ C. Using
the tool outside of this temperature range will decrease the life
of the tool.
1. Insert the appropriate chisel and rotate it by hand to lock it
into the desired position. Refer to Bit and Bit Holder.
2. Using the mode selector dial
to Mode Selection.
3. Adjust the side handle
2
as necessary. Refer to Mounting
the Side Handle Assembly.
4. Place the chisel on the desired location.
5. Depress the ON/OFF rocker switch
6. To stop the hammer, release the ON/OFF rocker switch.
MAINTENANCE
Your D
WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
4
to select the
Application
Chisel bit position adjustment
Light chipping, chiseling
and demolition
4
must be pointing
4
until it points towards
4
to the "Hammering/
, select chipping mode. Refer
4
1
.
installing attachments or accessories. Be sure the
trigger switch is in the OFF position. An accidental start-up
can cause injury.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.
WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Optional Accessories
WARNING: Since accessories, other than those offered
by D
WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Various types of SDS MAX chisels are available as an option.
Accessories and attachments used must be regularly lubricated
around the SDS MAX fitment.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
English
WALT recommended
e
7
Publicité
