Jennair INSTAI.L JBSFS42NM Instructions D'installation page 15

Side Trim
11/16" (18 mm)
1/2" (12.2 mm)
9/16" (13.9 mm)
Inset Installation Dimensions
1. Measure the distance from point A (as shown) to the
back wall. Add 1/16" (1.6 mm) to this measurement to
allow the side panel to fit into the trim.
2. If the panel is more than 11/32" (8.7 mm) thick, route
the front edge to allow the side panel to fit into the
trim.
A
5/8" (15.7 mm)
Inset Installation Dim
1. Measure the distance from point A (as shown) to back
wall.
2.
Route the front edge of the support board or attach
a 3/8" (9.5 mm) board to hold the panel in the cabinet
side trim.
A
15