KIKKA BOO ANGEL'S HUG Mode D'emploi page 6

WARNINGS
• Welcome to purchase this electric baby swing, this is the instruction together with the swing for you correctly and safe using the product.
• Please read the instruction of the swing carefully before using. It may cause injury to the infant if operating the swing not according to • The infant
must be removed of the swing before folding, and forbid to swing. Must extend the two legs of the swing to the widest position before using the swing.
• KEEP AWAY FROM FIRE !
• Never leave infant unattended in swing.
• Make sure all the locking equipments are installed well before using the swing.
• Always use the seat belt when the infant is in the swing.
• Always use the restraint system.
• It is forbiden to use the swing in a unsmooth surface to avoid any injury to the infant.
• Discontinue to use the swing when infant attempts to climb out.
• Discontinue to use of cradle swing when infant can roll over or push up on hands and knees.
• Do not use the swing once your child can sit unaided.
• This swing is not intended for prolonged periods of sleeping.
• It is dangerous to use this swing on an elevated surface, e.g. a table.
• Never use the toy bar to carry the swing.
• Age range: 0-6 months.
• The maximum weight of the child for which the swing is intended, is 9 KGS.
• This swing does not replace a cot or a bed. Should your child need to sleep, then it should be placed in a suitable cot or bed.
• Do not use the swing if any components are broken or missing.
• Do not use accessories or replacenment parts other than those approved by the manufacturer or supplier.
• The product should be installed by an adult.
I. CONTENTS:
1- Main model & Toy frame; 2- Seat support frame; 3- Dinner plate with toys; 4- Seat frame; 5- Front feet cover; 6- Left rear foot; 7- Right
rear foot; 8- Right support tube; 9- Left support tube; 10- Lower boom tube;
SCREWS: A- Screw of lower boom tube; B- Screw of lower boom plate; C-Screw of front feet cover; D- Screw of boom tube;
II. SEAT INSTALATION
WARNING! THIS ITEM ONLY CAN BE INSTALLED BY ADULT
2. 1. As shown in below pictures, insert the seat frame into the seat supporting tube according to the direction of arrowhead, and make
sure all the tubes are installed well.
Remarks: after compliting the installation, the seat frame direction is downward as the picture shows.
2.2. As shown in below pictures, install the lower boom and the bottom of seat supporting frame well and then use the screw No.A and B
to lock them.
2. 3. Install the seat pad to the seat, and then install the dinner plate with toys well as shown in below pictures.
III. INSTALATION THE SWING FRAME
3.1. As shown in pictures, insert the front feet cover to left and right legs, and then use the screw C to lock them.
3.2. As shown in below pictures, combine right behind leg with right supporting tube (remember to install the part with the same
marks), then install the left behind leg and left supporting tube the same way.
3.3. Install the right supporting tube and the main model, should pull out PE inside the supporting tube and metal tube of main
model before assembly the machine, then move out the mains connections from the PE tube. As shown in below pictures, rstly collect
the wire, then combine the right supporting tube and the main model, nally install the left supporting tube and the main model.
3.4. INSTALL THE SEAT AND THE SWING FRAME: Combine the seat frame and the swing frame before installation, and then use screw D to lock them.
ENGLISH