Always A Good Water Quality; Disassembling, Cleaning And Storing; Disassembling; Cleaning - Wehncke Family Pool Venice 12293 Mode D'emploi

PoolBuch.book Seite 17 Mittwoch, 28. Januar 2009 7:15 19

6. Always a Good Water Quality

DANGER:
• Observe the instructions for the filter pump and all
chemicals.
• Noxious bacteria and algae can build up in dirty
water.

7. Disassembling, Cleaning and Storing

7.1 Disassembling

1. Separate filter pump from the source of electricity.
2. Close plug of the inlet and outlet equipment onn the
inside of the pool and completely remove the filter
pump.
3. Lay one end of the hose in an area in which the
water can safley run, like a rain water discharge
or drain for example.
NOTE: The hose end must be lower than the pool in
order to ensure a complete emptying.
4. Affix the other end of the hose to the discharge
opening.

7.2 Cleaning

ATTENTION: Do not use any strong cleaning agents or
brushes for the cleaning.

7.3 Fold together and store

Pool Liner and Tarpulin
1. Let the pool liner lie in the sun for a while before
folding together. The warmth makes the material
softer and the liner can be more easily folded.
ATTENTION: If the liner or the tarpulin is stored when
wet, then mold build-up and stains occur.
2. The dried pool should be carefully folded together
and (if necessary) wrapped in the ground foil or a
similar cover.
• An excessive amount of chlorine or a too low (acidic)
pH value can damage the pool foil. The water must
be treated immediately.
Observe the water primer
A water primer is enclosed with the pool set. By all
means follow the directions in the water primer.
5. Open the discharge plug on the pool bottom and
the water automatically begins emptying.
6. Remove the hose after emptying and close
the discharge opening on the inside of the
pool again.
7. Leave the pool assembled for a few hours until it is
completely dried.
8. When the pool is dry, remove the rods and let out
the air from the upper ring.
9. Turn the pool over so that the underside can dry as
well.
• Let the pool liner dry completely before cleaning.
• Remove dry debris with a soft brush or rag.
Further Parts
• Only after all of the parts are completely dried, lay
them preferably in the original container for storage.
• The pool and all of its parts such as the pump, the
cover, the ladder, hoses and metal parts should be
stored together in an appropriate, warm and dry
room.
English 17