Assembling And Filling The Pool; Assembly - Wehncke Family Pool Venice 12293 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
PoolBuch.book Seite 15 Mittwoch, 28. Januar 2009 7:15 19
• Location:
not under power supply lines
not under trees
not directly above supply lines or telephone
lines.
assembled at least 3.5 meters distance from
source of electricity

5. Assembling and Filling the Pool

5.1 Assembly

ATTENTION: At no point may the pool be dragged
along the ground. The pool could be ripped or other-
wise damaged. If you must change the position, re-
gather the pool and carry it with a second person to
another place.
1. Carry the pool to an appropriate spot.
2. Lay a ground sheet on the assembly site when
possible. The ground sheet must lie evenly and
wrinkle-free.
ATTENTION: If you want to assemble the pool on
a concrete or asphalt surface, a ground sheet must
be used.
3. Carefully unfold the pool. The outer side of the wall
is face-up. Let the pool lay in the sun preferable for
an hour. The warmth makes the material more
flexible and eases the assembly.
4. The hose attachments show in which direction the
filter pump should later stand. Measure the
distance from the socket. Can the filter pump be
attached?
5. Attach the feet to the metal supports.
6. Insert the metal supports in the tunnel so that the
bulge at the head end fits with the join at the end of
the tunnel. The ends of the bulge face right and left
to the pool wall (NOT to the side with the water).
Please follow the drawings. This is the only way to
• NEVER use sand or other levelling material beneath
the pool liner!
ensure even pressure of the pool foil on the metal
rod and prevent it from tearing.
7. Inflate the ring with a pump.
8. When the ring is partially filled with air, erect the
metal supports vertically.
9. Inflate the ring completely but not too firmly.
Hose attachments
10. Go barefoot into the pool and remove all wrinkles in
the bottom.
11. Adjust the metal supports so that they stand
vertically. If necessary, place the feet in another
position.
12. Check if the pool is actually circular.
Note the length of the cable of your filter pump.
It must be able to be connected without
extension cord.
in an open area with direct sun radiation for
natural heating of the water
English
15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Family pool venice 12294Family pool venice 12295

Table des Matières