CAME 806SL-0370 Mode D'emploi page 16

Deleting users
Users can only be deleted from the keypad selector.
Single user
1 Use the keypad to enter the installer password
and press the following keys in sequence: (#),
(7), (#).
2 Enter the position number of the user you want
to delete (see table ) followed by the (#) key.
3 Confirm the position number of the user
followed by the (#) key.
To interrupt the procedure, press the (*) key and the selector will emit 3 short beeps;
alternatively, wait for 20 seconds.
All users
1 Use the keypad to enter the installer password
and press the following keys in sequence: (#),
(7), (#)
2 Press the (0) key three times followed by the
(#) key.
3 Press the (0) key again three times followed by
the (#) key
To interrupt the procedure, press the (*) key and the selector will emit 3 short beeps;
alternatively, wait for 20 seconds.
Changing operating mode on OUT2
The procedure for changing a function on OUT2 can be performed from the S0002P card or the
keypad selector.
From the S0002P card
1
Press the delete all code key ❸ (CLEAR).
A long beep will sound from the
selector to confirm.
If the number is not found in
the memory or is incorrect, the
selector will emit 10 short beeps.
A long beep will sound from the
selector to confirm.
The warning LED remains on.