CAME 806SL-0370 Mode D'emploi page 18

Managing the expansion board
Before backing up the user data, make sure the expansion board has been inserted. Disconnect
and then restore power to the board.
Backing up data from the S0002P card to the expansion board
1
Press and hold the delete all code key ❸ until
the LED starts flashing.
2
Press save key ❷
Backing up data from the expansion board (first 50 users) to the S0002P card
1
Press and hold the delete all code key ❸ until
the LED starts flashing.
2
Press save key ❶
Restoring factory settings
This procedure deletes all users and resets the installer password and the default OUT2 function.
1 From the S0002P card, press and hold the delete all
code key ❸ for 20 seconds while the warning LED
stays on.
Operation
1 Use the keypad selector to
enter the code saved followed
by the (#) key or put the saved
magnetic keycard near the
transponder.
Up to 5 code errors are permitted before the card is deactivated for approximately 1 minute.
The warning LED remains on for 1
second.
The warning LED remains on for 1
second.
The keypad selector will emit a long beep and the
back will light up green, while the transponder
selector back will light up green only.
If this does not happen, the keypad selector will
emit 3 short beeps, while the transponder selector
will not do anything.