Teaching-In Directly In To Homematic Devices - HomeMatic HM-LC-Sw1-Pl-DN-R1 Mode D'emploi

Start-up
remote control), you must teach it in first. You can teach-in the switch ac-
tuator directly to other Homematic devices or to the Homematic Central
Control Unit:
5.2.1

Teaching-in directly in to Homematic devices

If you want to teach-in the switch actuator to one or more Homematic
devices, the teach-in mode of both devices has to be activated first. To
do this, proceed as follows:
During teach-in, please make sure you maintain a distance of at
least 50 cm between the devices.
Activate the teach-in mode of your switch actuator.
• Therefore, press and hold the channel button (A) for at least 4 sec-
onds. The device LED (B) will flash slowly to indicate that teach-in
mode is active. The teach-in time is 20 seconds.
• Now put the device you wish to teach-in to the switch actuator
(e.g. Homematic remote control, see the following fig.) into teach-
in mode. Remove the battery compartment cover and press the
teach-in button briefly using a pointed object.
26
> 4 s