Publicité
Les langues disponibles
Les langues disponibles
reproductive harm. Some examples of
these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and
cement and other masonry products, and
• arsenic and chromium from chemically-
treated lumber (CCA).
Your risk from these exposures varies,
depending on how often you do this type
of work. To reduce your exposure to these
chemicals: work in a well ventilated area,
and work with approved safety equipment,
such as those dust masks that are specially
designed to filter out microscopic particles.
• Avoid prolonged contact with dust
from power sanding, sawing, grinding,
drilling, and other construction
activities. Wear protective clothing
and wash exposed areas with soap
and water. Allowing dust to get into
your mouth, eyes, or lay on the skin may
promote absorption of harmful chemicals.
WARNING:
ALWAYS use safety
glasses. Everyday eyeglasses are NOT
safety glasses. Also use face or dust mask if
drilling operation is dusty. ALWAYS WEAR
CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CPA
Z94.3),
• ANSI S12.6 (S3.19) hearing
protection,
• NOSH/OSHA respiratory protection.
WARNING:
Use of this tool can
generate and/or disperse dust, which
may cause serious and permanent
respiratory or other injury. Always use
NIOSH/OSHA approved respiratory
protection appropriate for the dust
exposure. Direct particles away from face
and body.
CAUTION:
Wear appropriate hear-
ing protection that conforms to ANSI
S12.6 (S3.19) during use. Under some
conditions and duration of use, noise from
this product may contribute to hearing
loss.
SAVE THESE
INSTRUCTIONS
SYMBOLS
The label on your tool may include the
following symbols. The symbols and their
definitions are as follows:
V ..................volts
A ..................amperes
Hz ................hertz
W .................watts
min ..............minutes
or AC ......alternating current
or DC ...direct current
n o ................no load speed
................Class I Construction
(grounded)
................earthing terminal
...............safety alert symbol
................Class II Construction
(double insulated)
.../min or rpm...revolutions or
....................Read instruction manual before use
.................Use proper eye protection
........................Use proper hearing protection
....................Use proper respiratory protection
SFPM ......... surface feet per minute
SPM ............ Strokes per minute
• When using an extension cord, be sure
to use one heavy enough to carry the
current your product will draw. An
undersized cord will cause a drop in line
voltage resulting in loss of power and
overheating. The table shows the correct
size to use depending on cord length
and nameplate ampere rating. If in doubt,
use the next heavier gauge. The smaller
the gauge number, the heavier the cord.
Minimum Gage for Cord Sets
Volts
120V
0-25
240V
0-50
AmpereRating
More
Not more
Than
Than
0
-
6
18
6
-
10
18
10 -
12
16
12 -
16
14
Recommended
FUNCTIONAL DESCRIPTION
1. Variable speed switch
2. Lock-off button
3. Saw blade locking lever
4. Shoe
5. Blade
6. Battery (sold separately)
3
4
reciprocation per minute
Total Length of Cord in Feet
26-50
51-100
101-150
51-100 101-200
201-300
American Wire Gage
16
16
16
14
16
14
12
Not
2
1
4
5
14
12
12
6
Publicité
