Philips HD7826 Mode D'emploi page 28

EnglisH
28
Problem
The light ring
around the
on/off button
continues to
flash rapidly.
Solution
Make sure you start the descaling cycle by pressing
the 1-cup button and the 2-cup button at the
same time. See chapter 'Descaling' for a complete
description of the descaling procedure.
Make sure you do not interrupt the descaling cycle.
During the descaling cycle, hot water comes out of
the coffee spout at intervals and the machine stops
descaling 3 to 4 times to let the descaling mixture
act and to heat up again. If you press the on/off
button to interrupt this cycle, the CALC light stays
description of the descaling procedure.
Make sure you use four full water reservoirs to
complete the descaling procedure: two reservoirs
filled with descaling mixture and two reservoirs
filled with fresh water. You start the two descaling
cycles and the two flushing cycles by pressing the
1-cup button and the 2-cup button at the same time.
If you do not complete the descaling procedure,
scale residues remain behind in the machine. This
causes scale to build up more quickly and may cause
permanent and irreparable damage to the machine.
Do not switch the machine off during the descale
process. If you switch off the machine, you have to
restart the whole descaling procedure.
Make sure that:
the water reservoir is placed properly;