Haier HWS84GA Manuel D'utilisation page 19

EN
1. Unpacking
Take the appliance out of the packaging.
Remove all packaging materials including the foam base and all adhesive tape hold-
ing the accessories.
2. Environmental conditions
the temperature inside the appliance and its energy consumption. Do not install the appli-
ance near other heat-emitting appliances (ovens, refrigerators) without isolation.
3. Space requirements
Required space to open the door (Fig. 3):
Width
in mm
W1 W2 D1
495 630 535 1033 1047
4. Ventilation space
For safety and energy reasons, the required ventilation
distance of 10 cm in all directions must be observed
(Fig. 4).
WARNING!
Keep ventilation openings in the appliance or in the in-built structure clear of ob-
struction. This refrigerating appliance is not intended to be used as a built-in appliance
5. Aligning the appliance
surface.
1. Tilt the appliance slightly backwards (Fig. 5).
2. Set the adjustable front feet to the desired level
by turning them.
3. The stability can be checked by alternately
bumping on the diagonals. The slight swaying
should be the same in both directions. Other-
wise the frame can warp; possible leaking door
seals are the result. A low tendency to the rear
facilitates the closing of the door.
Depth Distance to wall
in mm in mm
D2 D3
Installation
D4
100
10 cm
10 cm
1.
max 45°
3.
3
W1
D4
D1
D2 D3
W2
4
10 cm
10 cm
5
2.
15