Festool CLEANTEX CTL 26 E Notice D'utilisation D'origine/Liste De Pièces De Rechange page 13

6.3 Connecting electric power tools
WARNING
Risk of injury
Observe the maximum appliance socket
connected load (see chapter "Technical
data")
Switch off the electric power tool.
Connect the electric power tool to the ap-
pliance socket [1-3].
Special features of CTL26 E SD
– CTL 26 E SD E/A: Socket module with au-
tomatic switch-on function for the use of
two electric power tools: e.g. 2 sanders, 1
jigsaw + 1 sander
– CTL 26 E SD: Socket module with perma-
nent power supply for use as extension ca-
ble: e.g. charger, lamp, etc.
6.4 Connecting pneumatic tools
WARNING
Risk of injury
Switch off the air tool.
Automatic on/off switch for air tools
(CTL 36/48 E LE, CTL 36/48 E LE AC or
accessories)
with compressed air module in module slot
[1-2]
Recommendation:
– Attachment of service unit VE (495886):
compressed air filtered and lubricated
– Use of IAS system with IAS connector
(454757) for Festool air tools
Requirement: tool with operating pressure
of 6 bar!
6.5 Special features of the CTL 36 E
AC- LHS
To use the mobile dust extractor in combina-
tion with the PLANEX:
Use kink-resistant suction hose D 36 mm
x 3.5 m-AS.
Use a special suction sleeve for connect-
ing the PLANEX.
Use closing slide CT-VS between the in-
take opening [1-1] and suction hose.
Attach the tool holder.
Always use with a disposal bag!
7 Settings
7.1 Adjusting the suction power
Use the rotary knob [1-9].
7.2 Temperature cut-out
A temperature cut-out switches the mobile
dust extractor off when it reaches a critical
temperature to prevent overheating.
Switch off the mobile dust extractor, allow
to cool for about 5 minutes then switch on
again.
Not possible to switch on: contact Festool
service workshop.
7.3 AUTOClean - Cleaning the main
filter (only versions with Auto-
Clean)
Only in conjunction with disposal
bag (compliance with dust class 'L').
Not suitable for wet extraction!
Automatic cleaning
Adjust the frequency using the rotary knob
[1-7].
Manual cleaning
Turn the switch [1-8] to the AC symbol.
Full manual cleaning
Cover the end of the nozzle or suction
hose with your hand or closing slide CT-VS
(497926) for 2 seconds.
Turn the switch [1-8] to the AC symbol.
8 Working
8.1 Extracting dry materials
CAUTION
Hazardous dust
Damage to the respiratory passage
Always use a filter or disposal bag!
When extracting large quantities of oak
or beech wood dust or dust that ex-
ceeds the permitted limit values, only
extract from a single machine (electric or air
tool).
Observe the following when extracting dust
generated by operating electric power tools:
Ensure there is adequate ventilation!Observe
regional regulations!
Limit values: exhaust air max. 50% of the
clear air volume
CTL
GB
13