JUNO JKSN606F5 Notice D'utilisation page 28

28
Problem
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
The hob deactivates.
Residual heat indicator does
not come on.
Automatic Heat Up function
does not operate.
You cannot activate the out‐
er ring.
There is a dark area
on the multiple zone.
The sensor fields become
hot.
comes on.
Possible cause
The fuse is blown.
You touched 2 or more sen‐
sor fields at the same time.
There is water or fat stains
on the control panel.
You put something on one
or more sensor fields.
You put something on the
sensor field .
The zone is not hot be‐
cause it operated only for a
short time.
The zone is hot.
The highest heat setting is
set.
You decreased the heat set‐
ting to .
It is normal that there is a
dark area on the multiple
zone.
The cookware is too large or
you put it too near to the
controls.
Automatic Switch Off oper‐
ates.
Remedy
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Activate the hob again and
set the heat setting in less
than 10 seconds.
Touch only one sensor field.
Clean the control panel.
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
If the zone operated suffi‐
ciently long to be hot, speak
to an Authorised Service
Centre.
Let the zone become suffi‐
ciently cool.
The highest heat setting has
the same power as the func‐
tion.
Start from and only in‐
crease the heat setting.
Activate the inner ring first.
Put large cookware on the
rear zones if possible.
Deactivate the hob and acti‐
vate it again.