Disposing Of The Packaging; Disposing Of Your Old Refrigerator; Placing And Installation - Beko BFBF3018SS Manuel D'utilisation

Masquer les pouces Voir aussi pour BFBF3018SS:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Disposing of the packaging

The packing materials may be
packing materials out of the reach
of children or dispose of them by
classifying them in accordance with
the waste instructions stated by your
local authorities. Do not dispose of
them along with the normal household
waste.
The packing of your refrigerator is
produced from recyclable materials.
Disposing of your old
refrigerator
Dispose of your old refrigerator without
giving any harm to the environment.
You may consult your authorized
dealer or waste collection center of
your municipality about the disposal
of your refrigerator.
cut out the electric plug and, if there
are any locks on the door, make them
inoperable in order to protect children
against any danger.

Placing and Installation

A
If the entrance door of the room
where the refrigerator will be installed is
not wide enough for the refrigerator to
pass through, then call the authorized
service to have them remove the
doors of your refrigerator and pass it
sideways through the door.
1. Install your refrigerator to a place that
allows ease of use.
2.
sources, humid places and direct
sunlight.
3. Place your refrigerator on an even
floor surface to prevent jolts.
4. Your product requires adequate air
circulation to function efficiently. If the
product will be placed in an alcove,
remember to leave at least 5 cm
clearance between the product and
the ceiling, rear wall and the side
walls.
5. If the product will be placed in an
alcove, remember to leave at least 5
cm clearance between the product
and the ceiling, rear wall and the side
walls. Check if the rear wall clearance
protection component is present at its
location (if provided with the product).
If the component is not available, or if
it is lost or fallen, position the product
so that at least 5 cm clearance shall
be left between the rear surface of the
product and the wall of the room. The
clearance at the rear is important for
efficient operation of the product.
6. If the floor is covered with a carpet,
your product must be elevated 25
mm from the floor.
11
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Bfbf3018ssimBfbf3018sslBfbf3018ssiml

Table des Matières