Sony SU-B551S Mode D'emploi page 2

Notice for customers in the South
Africa
The Euro/South Africa converter plug should be fitted as
follows.
1
Insert the power supply or CEE7
plug in to the converter plug.
2
Use an appropriate screwdriver to
attach the screw tightly without
damaging the screw head.
3
TEST: Grip the converter plug,
and pull the VDE cord set/
transformer to ensure it is fully
secure, if not then increase the
torque setting and further tighten.
Re-test.
The converter plug is now ready for use.
Notice for customers in India
Attach the supplied plug adaptor.
On Safety
Thank you for purchasing this product.
Products by Sony are designed with safety in mind.
Incorrect use may result in a serious injury through
fire, electric shock, the product toppling over, or the
product being dropped. Be sure to observe the
precautions for safety to prevent such accidents.
This instructions manual shows the correct handling of the
product and important precautions necessary to prevent
accidents. Be sure to read this manual thoroughly and use the
product correctly. Keep this manual available for future
reference.
The manufacturer of this product is Sony Corporation, 1-7-
1 Konan Minato-ku Tokyo, 108-0075 Japan. The
Authorized Representative for EMC and product safety is
Sony Deutschland GmbH, Hedelfinger Strasse 61, 70327
Stuttgart, Germany. For any service or guarantee matters
please refer to the addresses given in separate service or
guarantee documents.
2
(GB)
CAUTION
Specified products
This stand is designed for use with the Sony products
specified below. Do not install other than the specified
products.
The following products are subject to change without notice,
may be out of stock, or discontinued.
Also, certain models are sold in some regions.
SU-B551S KDL-55HX92x/55HX82x/55NX72x
SU-B461S KDL-46HX92x/46HX82x/46NX72x
SU-B401S KDL-40NX72x
* In the actual model names, the "x" indicates numbers and/or
characters specific to each model.
Location of the identification label
Label for Model No. is located on the rear of the TV Stand.
WARNING
If the following precautions are not observed,
serious injury or death can result through fire,
electric shock, or the product toppling over.
Be sure to take measures to prevent
the TV Stand from toppling over.
If you fail to do so, the TV may topple over and cause injury.
Anchor the TV Stand and the rack, etc., to prevent toppling
over.
Be sure to install the TV Stand on a
stable surface.
If you install the TV Stand on an unstable
surface, it may lose its balance and topple
over or fall off. This may cause injury or
property damage.
Do not lean on or hang from the TV
with the TV installed on the TV
Stand.
The TV Stand may topple over, or the TV
may fall and cause serious injury or death.
LCD colour TV