Optional Accessory - Makita TM30D Manuel D'instructions

Cutting, sawing and scraping
CAUTION:
Do not move on the tool forcibly
in the direction (eg. towards either side) of tool
application with no cutting edge. It may damage
the tool.
Put the application tool on the workpiece.
And then move the tool forward so that the application
tool movement does not slow down.
NOTE: Forcing or excessive pressure on the tool may
reduce efficiency.
NOTE: Before cutting operation, it is recommended to
preset the orbital stroke rate 3 - 5.
Sanding
CAUTION:
Do not reuse a sanding paper used
for sanding metal to sand wood.
CAUTION:
Do not use a worn sanding paper
or sanding paper without grit.
Apply a sanding paper on the workpiece.
NOTE: Using a test material sample to try is recom-
mendable to determine a correct orbital stroke rate
suitable for your work.
NOTE: Use a sanding paper with the same grit until
sanding the whole workpiece is completed. Replacing
a sanding paper with different grit sanding paper may
not get a fine finish.
Dust extraction attachment

Optional accessory

CAUTION:
Do not use the dust extraction
attachment when sanding metal. Sucking spark
and hot particle results in smoking and ignition.
► 1. Joint 2. Nozzle band 3. Dust nozzle 4. Dust
attachment 5. Spacer 6. Felt ring (ø 47 mm (1-7/8"))
7. Pad (with STARLOCK marking) 8. Application
tool installation bolt 9. Felt ring (ø 37 mm (1-7/16"))
10. Pad (with OIS marking)
1. Install joint, dust nozzle and dust attachment.
2. Install the nozzle band on the tool so that its pro-
trusions fit in the holes in the tool to secure it.
8 ENGLISH
5
6
7
8
3
9
10
8