Optional Accessory - Makita HM1512 Manuel D'instruction

Dust extractor attachment

Optional accessory

The dust extractor attachment is intended for reducing
blown-away dust and particles when chiseling in a
ceramic material such as concrete.
1.
Install the hose holder (A).
Loosen the clamp nut, and then remove the hex bolt.
Install the hose holder (A) between the hex bolt and the
clamp nut by tightening the clamp nut firmly.
2
1
► 1 . Hex bolt 2. Hose holder (A) 3. Clamp nut
2. Attach the hose holder (C) to the cord guard.
► 1 . Cord guard 2. Hose holder (C)
3. Attach the dust cover and the hose to the tool, and
then fix the hose to the hose holders.
3
► 1 . Dust cover 2. Hose 3. Hose holder (A) 4. Hose
holder (C)
4. Connect the hose to the hose of the vacuum
2
cleaner with the hose joint.
NOTE: If the hose is not included, attach the dust
cover to the cleaner's joint or attach it to Makita's
hose ø28.
5. Adjust the distance between the dust cover and
1
the tip of the chisel or bull point.
For the self sharpening bull point, adjust the dust cover
not to veil the grooves of the self sharpening bull point.
For the bits other than the self sharpening bull point, the
recommended distance is 30 mm (1-3/16") to 100 mm
(3-15/16").
► 1 . Groove 2. 30 mm (1-3/16") to 100 mm (3-15/16")
7 ENGLISH
1
4
3
2
1
2