Publicité
Les langues disponibles
Les langues disponibles
•
WARNING: The supply cord must never come in touch with the housing of the heater as shown in picture
14.
6. a
ctivation and oPeration
USAGE BY REMOTE CONTROL (sold separately)
Inserting/replacing the battery (Figure 15)
•
When the remote is brand new, or if you observe problems of communication between the remote control and the
device, a new battery should be inserted.
•
The remote control battery type is CR2032 3V and to replace it:
-
remove the battery compartment cover;
-
insert the battery into the battery compartment with the positive side facing up;
-
close the battery compartment cover.
Description of the remote control (picture 16)
A - Identification of the product to be controlled;
B - On/stand-by;
C - Select next product;
D - Select previous product;
E - operation of the product at 1000W;
F - operation of the product at 2000W.
Using the remote control
•
To turn on/off the product:
-
select the device number to be controlled using the "C" or "D" buttons: the number of the selected device
lights up red while pressing (picture 17);
-
press the power/standby button "B";
-
a short acustic signal confirms that the heater has been turned on;
-
a long acustic signal confirms that the heater has been turned off.
•
To select the power consumption:
-
press the "E" button for the operation at 1000W (turns on a single heating element: picture 18);
-
press the "F" button for the operation at 2000W (turns on both elements: picture 19);
-
a short acustic signal confirms that the command has been received.
USAGE BY OTHER DEVICES (not provided)
As an alternative to the remote control the device can be managed using one or more control devices (not provided -
Picture 20 / Control) in order to regulate the emission of heat (thermostats, switches, timers, presence detectors etc.).
This operating mode must be selected at the time of installation choosing between the upper lamp, the lower lamp, or
both lamps lighting, by setting the corresponding identification number (see paragraph 2) as shown in picture 20. In this
configuration, the receiver of the remote control signals is deactivated.
7. m
aintenance
•
This product does not require any special maintenance.
•
Clean the product with a dry cloth once every 6 months.
•
If the product requires repairing, contact an authorised technical service centre.
•
When replacing the power cable, use a 3x1,00mm
by qualified personnel and never by the end user in order to avoid damaging the appliance and jeopardising
personal safety.
H05V2V2-F <HAR> type. This operation must be performed
2
15
Publicité
