NewAge Products PLATINUM Guide D'installation Et Mode D'emploi page 27

Lighting the Side burner
Manual Lighting
2
1
2
27
If the burners fail to light after a couple of attempts, it can be
lit using the supplied match lighting stick. Follow the steps
below for manual burner lighting.
1. Read and complete Pre-Cooking checklist.
2. Make sure all control knobs are set to off.
3. Always light side burner with lid open.
4. Turn fuel supply on.
5. Place the kitchen lighter close to the holes surrounding
1
6. Push the left control in and turn it to HIGH to ignite the
7. Repeat steps 6 for the other burner. If any of the burners
the burner and kight it up.
front burner. Check that the flame is lit . You should see a
flame.
fails to ignite during the lighting process, within five
seconds, stop, turn the burner control knob to OFF and
wait five minutes to allow the gas to clear before you try
again.