NewAge Products PLATINUM Guide D'installation Et Mode D'emploi page 15

Installing DSB on custom built cabinet
Layout for Non-combustible enclosure
2.375" Dia
Note:
Avoid abrasion of hose against the
opening. It is recommended to use a rubber
grommet at the opening.
Rubber grommet
MINIMUM 20 SQ IN (130 SQ
CM) OF VENTILATION
REQUIRED ON EACH END OF
CABINET.
5"
127mm
MAXIMUM
MINIMUM 10 SQ IN (65 SQ CM)
OF VENTILATION REQUIRED ON
EACH END OF CABINET.
MINIMUM 20 SQ IN (130 SQ
CM) OF VENTILATION
REQUIRED.
MINIMUM 10 SQ IN (65 SQ CM)
OF VENTILATION REQUIRED
Note:
These illustrations are for reference purpose only. Actual built-in cabinets and
15 installation may differ.
OUTDOOR GFI ELECTRICAL OULET
RECOMMENDED - LOCATE ON SAME SIDE
OF GRILL AS ROTISSERIE BRACKET.
1"
25.4mm
MAXIMUM
10in
1in
Back View
H
D
PARTITION TO ISOLATE
CYLINDER FROM GRILL
10in
WARNING
• The upper vent opening must be at least 20
square inches.
• The lower vent opening must be at least 10
square inches.
W
1.19"
0.39"