ELAC MIRACORD 50 Mode D'emploi page 29

TECHNICAL SPECIFICATIONS
TURNTABLE SECTION
• Drive System
• Motor
• Selectable Speeds
• Rotation Speed Variation
• Wow and Flutter
• Signal-to-Noise Ratio
• Platter
CARTRIDGE SECTION
• Type
• Frequency Response
• Channel Separation
• Channel Balance
• Vertical Tracking Angle
• Supported Load Impedance
• Stylus Pressure
• Cartridge Weight
• Headshell Weight
TONEARM SECTION
• Type
• Stylus Pressure Range
• Cartridge Weight Range
• Effective Arm Mass
• Overhang
• Offset Angle
• Anti-Skating Adjustment
• Main Bearing
PHONO EQUALIZER AMPLIFIER
• Type
• Phono Output
• Line Output
CONNECTOR
VOLTAGE
POWER CONSUMPTION
DIMENSIONS (H x W x D)
WEIGHT
Belt drive
DC motor
33⅓ and 45 rpm
+/-1 %
0.1 %
-67 dB or higher (A-weighted)
-60 dB or higher (unweighted)
Aluminum die cast
Audio-Technica AT91 moving magnet
20 Hz to 20 kHz
>18 dB
2.5 dB
20 degrees
47 kΩ
2.0 g +/-0.5 g
5.0 g +/-0.5 g
11.0 g (including screws, nuts and wires)
Aluminum tube
0 to 4.0 g
3.5 to 6.0 g
27.4 g
18.6 mm
25 degrees
0...4
Stainless steel
Moving magnet (MM)
2.5 mV (1 kHz, 3.54 cm/sec)
140 mV (-17 dBV)
RCA jacks including RCA cable
100 to 240 V AC / 50/60 Hz
1.5 W (less than 0.5 W at standby)
5.5" x 16.5" x 14.2"
140mm x 420mm x 360mm
12.1 lb / 5.5 kg (approx.)
27