ELAC MIRACORD 50 Mode D'emploi page 16

INITIAL STARTING UP
MAINS CONNECTION
An external switching power adaptor (DC 12 V / 0.5 A) is supplied with this turntable.
Your unit is ready to be connected to a mains voltage of 110 V / 60 Hz or 230 V / 50 Hz.
AMPLIFIER CONNECTION
There is a Phono/Line selector next to the RCA jack on the rear panel of the turntable.
If your amplifi er has "PHONO" input, switch the selector to "THRU",
and connect the RCA plug to the PHONO INPUT of your amplifi er.
If your amplifi er does not have "PHONO" input, switch the selector to "ON", and connect the RCA
plug to the "LINE" input of your amplifi er.
Red plug into R channel input, White plug into L channel input.
PLAYING A RECORD
1) Place the record on the turntable. If it is a 45 rpm, you need to place the adaptor
on the record spindle.
2) Choose the playing speed.
3) Release the pick-up arm clip.
4) Place the cartridge vertically over the fi rst track of the record the turntable starts turning.
5) Lower the cue lever to place the stylus in the groove
6) When playback is complete, push the cue lever to lift the tone arm and move it
back to the arm rest.
7) If you want to pause the playback, switch the knob to "off", and switch it to 33 or 45 to continue
the playback.
8) After fi nish the playback, please switch off the power to save energy.
14