Publicité
16
INSTALL THE FRONT LANDING PADS.
• Refer to the arrows
inside the bases and
orient the bases so that
the arrows face outward
from the vehicle.
• Use the 5 mm hex
wrench to install the
pad, base, conical washer
oriented as pictured, and
the long bolt as shown.
• Fully tighten to 4 Nm.
17
TEST THE INSTALLATION.
Jostle and rotate the Landing
Pad in all directions to ensure
it is securely installed.
19
Continue with SkyLine or Control Tower installation.
Instruction #1036108A - Page 6 of 10
INSTALL THE COVERS WHEN
18
THE RACK IS NOT ATTACHED.
Using the covers will help keep
4X
4X
the bases free of debris.
4 Nm
2X
2X
Publicité
