Publicité
APPLY SILICONE TO THE
5
REAR MOUNTING POINTS.
Apply a generous amount of
silicone around the rear tubes of
the rearmost mounting points.
INSTALL THE HARDWARE AT
7
THE REAR MOUNTING POINTS.
Use the 5mm hex wrench to install a flat
washer and a short bolt. Tighten until the
spacer is slightly compressed (.3 Nm of torque).
Instruction #1036108A - Page 3 of 10
INSTALLING SPACERS
tall spacer
intercalaire long
espaciador alto
2X
2X
.3 Nm
2X
2X
Use this image as a guide
to install the spacers in
the following steps. The
spacers must be installed in
the positions shown here.
6
PLACE THE SHORT SPACERS.
Place a short spacer and apply
silicone to the top of the spacer.
APPLY SILICONE TO THE
8
FRONT MOUNTING POINTS.
Apply a generous amount
of silicone around the front
tubes at the forwardmost
mounting points.
2X
2X
2X
2X
Publicité
