Publicité
13
INSTALL THE REAR LANDING PADS.
• Refer to the arrows
inside the bases and
orient the bases so that
the arrows face outward
from the vehicle.
• Use the 5 mm hex
wrench to install the
pad, base, conical washer
oriented as pictured, and
the long bolt as shown.
• Fully tighten to 4 Nm.
APPLY SILICONE TO THE
14
FRONT MOUNTING POINTS.
Apply a generous
amount of silicone
around the rear tubes
at the forwardmost
mounting points.
Instruction #1036108A - Page 5 of 10
15
PLACE THE TALL SPACER.
and apply silicone to
the top of the spacer.
2X
2X
4 Nm
Place a tall spacer
2X
2X
2X
2X
Publicité
