Gree GMV-ND22T/B-T Manuel D'utilisateur page 16

Multi Variable Air Conditioners Cassette Type Indoor Unit
(3) Connect the decoration panel terminals (Female) to body terminals (male) as shown in
figure4.4.3.
4.4.2 Panel installation
(1) Detach the panel's Corner Cap, there is a mark "piping side" on one of the 4 corners,
adjust the panel direction so as to keep the mark and fittings on the same corner , as
shown in fig4.4.4
(2) Temporality hang the panel to body (there is four hangers on each corner of the panel,
hang the hangers to corresponding hooks on the body), as shown in fig 4.4.5.
(3) Detach the air inlet grille from panel, make a wiring connection of signal receiver. Notices
that the connection wire not stuck in the middle of body and panel, or may cause air
leakage and lead to condensation water drop.
(4) Tighten 4 screws at each corner of panel respectively, fix the panel on the body firmly.
(5) After tightening screws, reinstall the air inlet grille.
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
Fig 4.4.3
Fig 4.4.4
13