Bestway 58500E Manuel page 14

1. Now the sand filter is ready for use. Set
the Control Valve to the Filter function.
NOTE:
shock dry any excess water from yourself and the
sand filter.
IMPORTANT:
make sure the tank is placed steadily on its base and connected correctly
to the pump.
2. Switch on the sand filter to run it.
NOTE:
that water is returning to the pool and take note of the filter pressure on
Pressure Gauge. Generally, the recommended sand filter pressure is
less than 0.56 Bar (8.0 PSI) when it is running.
SAND FILTER MAINTENANCE
CAUTION:
sand filter is switched off and unplugged
before any maintenance begins or severe risk
of injury or death exists. As dirt builds up in
the sand filter, the pressure reading on
Pressure Gauge will increase. When the
Pressure Gauge is 0.56 Bar (8.0 PSI) or
higher, or water flow to the pool is too low, it is time to clean the sand. To
clean the sand bed, follow all instructions outlined previously in :
Backwash and Rinsing.
NOTE:
1. The Pressure Gauge is just used for measuring the water pressure, not
used for precision measurement.
2. We recommend you clean the sand bed once a month or less regularly
depending on how often the pool is used. Do not clean the sand too
frequently.
To prevent the risk of electrical
Before operation,
The sand filter has now started its filtering cycle. Check
You must ensure the
14
10
15
5
20
23
0
psi
bar