ECOVACS DEEBOT X1 TURBO Manuel D'instructions page 13

Wi-Fi Connection
Before Wi-Fi setup, make sure DEEBOT, mobile phone, and Wi-Fi network
meet the following requirements.
DEEBOT and Mobile Phone Requirements
• DEEBOT is fully charged and the power switch of DEEBOT is turned on.
• Wi-Fi status light slowly flashes.
• Turn off mobile phone's cellular data (you can turn it back on after setup).
Wi-Fi Network Requirements
• You are using a 2.4GHz or 2.4/5 GHz mixed network.
• Your router supports 802.11b/g/n and IPv4 protocol.
• Do not use a VPN (Virtual Private Network) or Proxy Server.
• Do not use a hidden network.
• WPA and WPA2 using TKIP, PSK, AES/CCMP encryption.
• WEP EAP (Enterprise Authentication Protocol) is not supported.
• Use Wi-Fi channels 1-11 in North America and channels 1-13 outside North
America (refer to local regulatory agency).
• If you are using a network extender/repeater, the network name (SSID) and
password are the same as your primary network.
Please be aware that the realization of intelligent functions such as remote
startup, voice interaction, 2D/3D map display and control settings, and
personalized cleaning (depending on different products) requires users to
download and use ECOVACS HOME App, which is constantly updated. You
need to agree to our Privacy Policy and User Agreement before we can process
some of your basic and necessary information and enable you to operate the
product through ECOVACS HOME App. If you do not agree with our Privacy
Policy and User Agreement, some of the aforementioned intelligent functions
cannot be realized through ECOVACS HOME App, but you can still use the
basic functions of this product for manual operation.
EN 12
Charging DEEBOT
1
Assemble Clean Station
2
Clean Station Placement
Keep the area around the Station clear of objects and reflective object surfaces.
* If there are reflective objects such as mirrors and reflective skirting lines near the
Station, the bottom 14cm of that should be covered.
Do not place the Station under direct sunlight.