Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Turn off the engine and remove the key from the ignition before installing tracks on your ATV to avoid
asphyxiation from exhaust fumes. These fumes are odourless, colourless and can be fatal.
Wear appropriate work clothes while you are installing tracks: safety glasses, steel-toed boots, and gloves.
Make sure that shirtsleeves, coats, scarves, laces and other articles of clothing or objects cannot get caught in
the moving parts.
During installation, do not turn the tracks with engine power until they are positioned on the ground and you are
in the driver's seat.
Do not make any adjustments to the tracks unless the engine is off and the hand brake is applied.
Always adjust the ATV's suspension to its maximum stiffness.
Apply thread locker (Loctite) to all nuts and bolts.
Correctly adjust the tension so the tracks stay in their proper position on the rollers.
Choose a clean levelled surface with good lighting and good ventilation when installing tracks on an ATV. Put the ATV in neutral
(N), turn off the motor, remove the key from the ignition, apply the hand brake and position chocks in front and in back of the
wheels that are in contact with the ground, to immobilize the vehicle.
You do not need to modify your ATV to install tracks. First identify the front and back tracks, as well as the left and right tracks.
If the edges of the fenders are in contact with the tracks, the fenders must be cut back slightly. THE ATV'S SUSPENSION
MUST ALWAYS BE AT MAXIMUM STIFNESS WHEN USING THE TRACKS..
19/12/07
INSTALLATION
w
w
w
w
w
w
.
.
t
t
j
j
d
d
.
.
c
c
a
a
99XG-008_ENG.doc
6
Publicité
Table des Matières
