Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Turn off the ATV engine and remove the key from the ignition before doing any maintenance on the tracks or
on the ATV (see ATV manual). This also applies before making any inspection.
Automatic Track tension
Tracks adjust automatically however should be checked regularly for best operation of the components according to season
and conditions.
Checking the condition of the hardware
To maintain your equipment in optimal working condition, replace damaged bolts as well as nylon nuts and any other part
subject to normal wear and tear such as the bearings and the tube covers on the frame. Replace them with original
manufacturer parts; see your authorized dealer for further information.
Inspect regularly all bolts and tighten them if necessary to avoid costly repairs. Make sure that your
equipment is in safe operating condition.
The nylon lock nuts are designed for one-time use only and must never be reused once they have been
removed.
To ensure long life, clean the rubber tracks with soapy water only.
Everyday after riding in mud, sand, etc, you must wash your track system with a low pressure gun to avoid
costly repairs.
Before removing the track system from the ATV, turn off the engine and remove the key from the ignition.
When removing the tracks system, take the same safety precautions you employed when assembling it (see installation).
To remove the track system, follow the steps in the INSTALLATION section in roughly reverse order. They are easy to
remove and only the track system itself has to be removed. Once removed, release the tension on the four tracks.
Store the track system under cover until you are ready to reinstall it for the next season; this is the time to inspect and check
the condition of the hardware. Have your local dealer to check and grease the hub bearings to stay out of problems every
season.
19/12/07
MAINTENANCE
REMOVAL
w
w
w
.
t
j
d
.
c
a
w
w
w
.
t
j
d
.
c
a
99XG-008_ENG.doc
8
Publicité
Table des Matières
