Akron STREAMMASTER 3578 Manuel page 3

INSTALLATION, OPERATING, AND MAINTENANCE INSTRUCTIONS
The following is intended to provide the basic instructions for installation, operation and maintenance of the StreamMaster electric
monitor, and to assist in attaining the best possible performance from the unit . Read and understand these operating instructions
before use .
TOOLS REQUIRED
• Utility Knife
• Medium Phillips screw driver
• Small Phillips screw driver
• Electrician's pliers (multipurpose, stripping and crimping)
PRODUCT RATINGS
Maximum Motor Current Draw:
12 volt versions
24 volt versions
Normal Operating Current: (Depending on operating conditions–pressure, flow, etc.)
12 volt versions
24 volt versions
Minimum Voltage: (Truck engine must be operating for proper voltage requirement . )
All 12 volt motors:
All 24 volt motors: 23 volts while operating
Mass: 39 lbs . (17 . 7 kg)
Maximum Flow: 2000 gpm (7600 lpm)
Maximum Pressure: 200 psi (14 bar)
Noise Emission: 95 DL @ 1m with maximum flow
PRODUCT WARNINGS
WARNING: Charge the unit slowly. Rapid charging may cause a pressure surge that has the potential to cause an injury, or
damage the monitor .
WARNING: DO NOT stow or deploy the StreamMaster monitor while flowing. Pressing the stow or deploy buttons causes the
nozzle to move automatically and the water stream may cause damage to equipment or injury to personnel.
WARNING: Aim the unit in a safe direction before pumping water through it. (i.e. Away from power lines)
STYLE 3578 STREAMMASTER™
(
• Medium flat screwdriver
• Small flat screwdriver
1
• /
14 . 0 amps each for elevation and rotation motors
3 . 0 amps for nozzle pattern motor
7 . 5 amps each for elevation and rotation motors
1 . 5 amps for nozzle pattern motor
3 . 0 to 10 . 0 amps each for elevation and rotation
0 . 7 amps for nozzle pattern motor
2 - 5 amps each for elevation and rotation motors
0 . 4 amps for nozzle pattern motor
11 . 5 volts while operating
Version Available)
inch hex head wrench
2
118026