Operation; Adjust The Observation Head; Place The Specimen On The Stage; Lamp Settings - VWR VisiScope 200 Serie Manuel

Masquer les pouces Voir aussi pour VisiScope 200 Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operation

Adjust the observation head

Loosen the lock-screw, turn the observation head to a comfortable position for observation, and then lock the
lock-screw.

Place the specimen on the stage

Lock the specimen slide on the mechanical stage using the slide holder. Ensure that the specimen is centred
over the stage opening by adjusting the coaxial stage controls.

Lamp settings

The microscope is fitted with a white LED illuminator. Before turning on the light, read the section about elec-
trical safety precautions. Insert the plug of the power supply into the jack on the rear and turn on the ON/OFF
switch. Turn the brightness adjustment knob to a brightness suitable for observation.

Adjust interpupillary distance (binocular models)

Hold the right and left side of the observation head with both hands and adjust the interpupillary distance by
turning the two parts until one circle of light can be seen, when looking down the microscope with both eyes.

Focus and diopter adjustment (binocular models)

Rotate the coarse focusing knob to bring the slide into focus using a low magnification objective. Adjust the
fine focusing knob to get the image sharp and clear while observing with your stronger eye, then turn the di-
optric adjustment ring on the opposite eyepiece until a sharp and clear image can be observed also with the
other eye. Turn the tension adjust knob to achieve a suitable focus tension without the specimen dropping out
of focus. When the image is in focus, turn the nosepiece to choose the objective you need.

Condenser adjustment

Hold the notched ring at the base of the condenser and rotate it up or down until you reach a clear and uni-
form sample illumination.
HOLD THIS NOTCHED
RING AND ROTATE IT

Set the numerical aperture

Adjust the aperture of the iris diaphragm to set the numerical aperture of the illuminator, thus controlling im-
age contrast and resolution.

Optional filter

The green glass filter can be inserted in the flip-out filter holder underneath the condenser.
7

Publicité

Chapitres

Table des Matières
loading

Table des Matières