Publicité
Les langues disponibles
Les langues disponibles
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications not expressly approved by Conair Corporation,
the manufacturer of this product and the party responsible for compliance could void
the user's authority to operate the equipment.
Oiling Instructions
IMPORTANT! It is highly recommended before each use to oil the blades with the oil
provided. This ensures optimum cutting performance.
For the first use you will need to use the oil supplied with the product, unscrew the cap
and cut off the very end of the plastic tube with a pair of scissors to release the oil.
To oil the blades ensure the unit is switched on. Gently squeeze the oil tube and apply
2 drops of oil onto the blades. Leave the unit on for a further few seconds to allow the
oil to thoroughly spread the length of the blades. Switch off the unit and remove any
excess oil by gently dabbing with a cloth.
To oil these
2 positions
Preserving the batteries
In order to maintain the optimum capacity of the rechargeable batteries, the appliance
has to be fully discharged every 6 months approximately. Then recharge the appliance
to full capacity, again for 3 hours.
FX673C IB-16_081.indd 7-8
Comb Guides
This appliance is supplied with 8 comb guides and a
left and right ear taper guide.
• To attach a comb guide, ensure the appliance is
switched off. Position the comb guide over the front
of the clipper blade and slide over the head. Push
and click the rear of the comb guide into position
(see Fig.1).
• To remove the comb
guide,
appliance is switched
off. Push the tab on the
rear of the comb guide
away from the head and
lift off (see Fig.2).
The appliance is also supplied with 2 taper guides
The taper guides can be used above the ear to get a clean line.
• Attach either the left or right guide depending on which ear you are cutting above.
• Angle the clipper and gently stroke around the ear towards the back of the neck.
Taper Control
The taper control lever enables fine cut adjustment for precision clipping.
• To increase the cutting length, push the lever down.
• To reduce the cutting length, push the lever up.
To oil these 2 positions
Preparation for Use
• Always inspect the appliance before use to ensure the clipper blades are free from
hair, debris etc.
• For best performance, use on clean, dry hair that has been combed until tangle-free.
• Ensure the appliance is sufficiently charged or plugged into the mains.
NOTE: The appliance should not be used for longer than 20 minutes when operated
from the mains.
ensure
the
Fig.1
Cutting Length
Grade
3mm
#1
6mm
#2
9.5mm
#3
13mm
#4
16mm
#5
19mm
#6
22mm
#7
25mm
#8
Fig.2
3/7/16 6:05 PM
Publicité
