Publicité
Les langues disponibles
Les langues disponibles
CORDLESS LITHIUM CLIPPER
The BabylissPro Cordless Lithium Clipper features Japanese steel blades with a unique
super sharp V cutting angle for ultra smooth, ultra powerful cutting and a high quality
even finish even on longer hair lengths. Lithium-ion technology gives sustained power
performance for reliable cordless use, even at lower charge levels. Can be used with
mains power or cordless for total convenience and control.
FEATURES
• Precision engineered Japanese steel blades with a super sharp V cutting angle
• Lithium-ion technology for sustained power performance
• Can be used corded or cordless
• 3 Hour full charge for approximately 75 minutes of use
• 30 Minutes quick charge for approximately 30 minutes of use
• 8 x comb guides for cutting grades 1-8
• Left and right ear taper comb guides
• Adjustable taper lever for convenience
• Lightweight, comfort grip design
• Cleaning oil
• Cleaning brush
• Storage pouch
• Professional 3m length power cord
OPERATING INSTRUCTIONS
Charging the Appliance
IMPORTANT! Only use the adaptor supplied with this appliance. This clipper is so easy
to use, but before you do anything you must take your time to charge the unit for 3 hours
before its first use. Even if you want to use it plugged in straight from the mains, this
initial supercharge ensures optimum power performance to give smooth fast cutting
every time. Maximum battery capacity will only be reached after 3 charging/discharging
cycles. A full charge will provide approximately 75 minutes use. A 30 minute quick
charge will provide approximately 30 minutes use.
When charging the appliance the blue LED charging light will flash slowly and
FX673C IB-16_081.indd 5-6
continuously until the battery has fully charged, then the blue LED charging light will
stop flashing but remain on.
Mains Operation
• Ensure the appliance is switched off.
• Connect the adaptor to the base of the appliance and plug the adaptor into a suitable
mains socket.
• The blue LED charging light will flash when the adaptor is correctly inserted into the
appliance and connected to the mains.
• The appliance is now ready for use.
• NOTE: The appliance should not be used for longer than 20 minutes when operated
from the mains.
Cordless Operation
• Insert the adaptor into the base of the appliance, plug into a suitable mains socket and
switch on. The blue LED charging light will flash when the adaptor is correctly inserted
into the appliance and connected to the mains.
• Once the appliance is fully charged the blue LED charging light will stop flashing but
remain on, unplug the adaptor from the mains.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
3/7/16 6:05 PM
Publicité
