Télécharger Imprimer la page

Pari LC plus Mode D'emploi page 6

Masquer les pouces Voir aussi pour LC plus:

Publicité

Les langues disponibles

Les langues disponibles

d. nebulIzer set-up
1.
clean/disinfect nebulizer cup:
e-F to clean and/or disinfect your nebulizer
prior to first use. Re-assemble nebulizer.
2.
connect tubing to compressor:
of Wing-tip
tubing to the air outlet on the
compressor. it should fit snugly (Fig. b).
3.
load
medication: Remove the nebulizer insert
by twisting counter-clockwise until it stops
and lift up (Fig.c). pour medication into the
nebulizer cup (Fig.D). Never fill past the max.
fill line of 8ml for the lc
for lc
staR. Replace the nebulizer insert
®
making sure the two alignment rings are lined
up with each other.
4.
attach mouthpiece or mask:
mouthpiece, attach the mouthpiece to the
nebulizer outlet with the expiratory valve facing
up. then attach the inspiratory valve cap by
pressing it firmly into the top of the nebulizer.
if using a mask, refer to the mask instructions.
5.
attach tubing to nebulizer cup:
other end of the Wing-tip
bottom of paRi reusable nebulizer (Fig. e).
6.
starting treatment:
position and turn the compressor "oN".
B
5 Questions? 1.800.Fast.neb (327.8632) | parI.com
Refer to section
insert one end
plus and 6ml
®
if using the
Firmly press
tubing to
sit in a relaxed, upright
7.
nebulizer position:
place the mouthpiece
on top of tongue and close lips around it.
take slow, deep breaths. as you inhale, the
inhalation valve opens.
8.
breathing:
For mouthpiece, inhale and exhale
slowly through your mouth. as you exhale,
the valve on the mouthpiece opens to allow
the exhaled mist to escape. For mask, place
mask over nose and mouth and inhale and
exhale slowly.
9.
complete treatment:
medication is gone or you hear a slight
"sputtering" sound. turn compressor off.
WInG-tIp
tubInG
it is normal if moisture or condensation
appears in your tubing during a treatment. this
can be a natural effect of your environment's
temperature. if this happens, finish your
treatment and then disconnect the tubing from
the nebulizer. leave the other end attached to
the compressor air outlet and let run for a few
minutes. the warm air from the compressor
will dry the inside of the tubing. use a damp
cloth to wipe the exterior of the tubing.
C
continue until the

Publicité

loading

Ce manuel est également adapté pour:

Lc star