Philips Satinelle Ice HP6493 Mode D'emploi page 9

4 Switch the appliance on by selecting the desired speed (fig. 4).
Select speed I for areas with little hair growth and for areas where
bones are located directly beneath the skin, such as knees and ankles.
Select speed II for larger areas with stronger hair growth.
5 Stretch your skin with your free hand to make the hairs stand
upright.
6 Place the appliance perpendicularly onto the skin with the on/off
slide pointing towards you and move it against the direction of
hair growth at a moderate speed (fig. 5).
Make sure both the epilating discs and the skin cooler are in proper
contact with the skin.
Press the appliance lightly onto the skin.
If you are not completely satisfied with the epilation result, try
moving the epilator more slowly over your skin.
7 Use the tab on the bottom end of the appliance to remove the
appliance from the skin cooler (fig. 6).
Epilating with the skin cooler for underarms and bikini
line
The special skin cooler for the underarms and the bikini line reduces
the number of active epilating discs. Combined with the large cooling
surface, this skin cooler makes epilating sensitive areas less painful.You
will get the best results when the hairs are not too long (max. 1cm).
1 Slide the insulating sleeve onto the skin cooler (fig. 7).
2 Snap the appliance onto the skin cooler (fig. 8).
3 Switch the appliance on by selecting the desired speed (fig. 4).
We advise you to use speed I.
4 To epilate the underam area, place one arm behind your head to
stretch the skin and place the appliance perpendiculary onto the
skin with the hand of the other arm (fig. 9).
ENGLISH
9